Other Concerns: No Engine Braking In Manual Low Position

WARNING: This page is about a different variant/trim than selected.

POSSIBLE COMPONENT REFERENCE CHART

Possible Component	Reference/Action
260 - ELECTRICAL ROUTINE
No electrical concerns
360 - HYDRAULIC/MECHANICAL ROUTINE
Main Control Valve Body
Bolts out of torque specification	Tighten bolts to specification.
Gaskets and separator plate - damaged, off location	Inspect for damage. Install new as required.
Low/reverse regulator valve, springs, clips - loose, stuck, binding, missing, misassembled	Inspect for damage. Repair or install new as required.
Low/reverse boost valve, springs, clips - loose, stuck, binding, missing, misassembled	Inspect for damage. Repair or install new as required.
Shift Solenoid D (SSD) not functioning correctly	Activate solenoid using scan tool. Refer to OUTPUT STATE CONTROL (OSC) MODE in this service information. Go to PINPOINT TEST A . Install a new solenoid as required. Refer to SOLENOIDS in this service information. Download a new solenoid body strategy into the PCM. Refer to SOLENOID BODY STRATEGY in this service information.
Low/Reverse Clutch Assembly
Seals - damaged	Inspect for damage. Install new as required.
Piston - damaged	Inspect for damage. Install new as required.
Friction - damaged, worn	Inspect for damage. Install new as required.
Cylinder hub - damaged	Inspect for damage. Install new as required.
Return spring assembly - damaged	Inspect for damage. Install new as required.