LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Escape Base, 2.5 7, AWD, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Automatic Transmission (6F35) (Except Hybrid)) >> Diagnosis And Testing >> Diagnosis By Symptom >> Diagnostic Routines >> Engagement Concern: No Forward

Engagement Concern: No Forward

WARNING: This page is about a different variant/trim than selected.
POSSIBLE COMPONENT REFERENCE CHART

Possible Component Reference/Action
201 - ELECTRICAL ROUTINE 
Powertrain Control System   
  • No electrical concerns
301 - HYDRAULIC/MECHANICAL ROUTINE 
Transmission Fluid Level   
  • Low transmission fluid level
  • Check transmission fluid level and adjust as necessary. Refer to PRELIMINARY INSPECTION  in this service information.
  • Condition
  • Carry out transmission fluid condition check. Refer to PRELIMINARY INSPECTION  in this service information.
Selector Lever Linkage (Internal/External) 
  • Damaged or out of adjustment
Incorrect Pressures 
  • Check pressure at LPC tap. Carry out Line Pressure Tests and Stall Speed Tests. Refer to SPECIAL TESTING PROCEDURES  in this service information. See the LINE PRESSURE CHART  for specification. If pressures are low, check the following possible components:
    • Main control valve body
    • Pump assembly
    • LPC  solenoid
  • Line Pressure Control (LPC) solenoid stuck - low
Main Control Valve Body   
  • Bolts out of torque specification
  • Adjust bolts to specification.
  • Gaskets and separator plate - damaged, off location
  • Inspect gaskets for damage. Install new as required.
  • Manual control valve - damaged
  • Inspect for damage. Install new as required.
Pump Assembly   
  • Bolts out of torque specification
  • Inspect for damage. Install a new pump as required.
  • Porosity/cross leaks/ball missing or leaking
  • Inspect for damage. Install a new pump as required.
  • Components - damaged
  • Inspect for damage. Install a new pump as required.