LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Escape Base, 2.5 7, AWD, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Mechanical - 2.5L (Hybrid)) >> In-Vehicle Repair >> Oil Pan >> Removal

Oil Pan: Removal

WARNING: This page is about a different variant/trim than selected.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING article.
  2. Drain the engine oil, then install the drain plug.
    • Tighten to 28 Nm (21 lb-ft).
  3. Remove the engine front cover. For additional information, refer to ENGINE FRONT COVER  in this service information.
  4. Remove the 4 oil pan-to-bellhousing bolts.
  5. Remove the 13 bolts and the oil pan.
scientia non olet · About LEMON Manuals