LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Escape Base, 2.5 7, AWD, Standard >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> Engine Mechanical - 2.5L (Except Hybrid) >> In-Vehicle Repair >> Crankshaft Rear Seal >> Removal

Crankshaft Rear Seal: Removal

  1. Remove the flexplate or flywheel. For additional information, refer to FLEXPLATE  or FLYWHEEL  in this service information.
  2. G00669076Courtesy of FORD MOTOR CO.

    Remove the 6 bolts and the crankshaft rear seal, discard the crankshaft rear seal.

  3. G00669080Courtesy of FORD MOTOR CO.
    NOTE: Do not use metal scrapers, wire brushes, power abrasive discs or other abrasive means to clean the sealing surfaces. These tools cause scratches and gouges, which make leak paths. Use a plastic scraping tool to remove traces of sealant.

    Clean and inspect the oil pan and cylinder block mating surfaces. Refer to RTV sealing surface cleaning and preparation in ENGINE MECHANICAL SYSTEM - GENERAL INFORMATION .

scientia non olet · About LEMON Manuals