LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Escape Base, 2.5 7, AWD, Standard >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Cooling (Except Hybrid) >> Removal And Installation >> Radiator - 3.0L (4V) >> Removal and Installation

Removal and Installation

  1. Drain the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING  in this service information.
  2. Remove the cooling fan motor and shroud. For additional information, refer to COOLING FAN MOTOR AND SHROUD  in this service information.
  3. Disconnect the radiator-to-degas bottle hose and upper radiator hose from the radiator.
  4. Disconnect the degas bottle-to-radiator hose from the radiator.
  5. Disconnect the lower radiator hose from the radiator.
  6. Remove the 2 A/C condenser-to-radiator bolts and position aside the A/C condenser from the radiator.
    • To install, tighten to 8 Nm (71 lb-in).
  7. Remove the radiator.
  8. To install, reverse the removal procedure.
  9. Fill and bleed the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING  in this service information.
scientia non olet · About LEMON Manuals