LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Escape Base, 2.5 7, AWD, Standard >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Cooling (Except Hybrid) >> Removal And Installation >> Coolant Pump - 3.0L (4V) >> Removal

Coolant Pump - 3.0L (4V): Removal

  1. Drain the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING  in this service information.
  2. Remove the Air Cleaner (ACL) outlet pipe. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING - 3.0L (4V) article.
  3. Disconnect the lower radiator hose from the thermostat housing.
  4. Remove the coolant pump belt. For additional information, refer to ACCESSORY DRIVE - 3.0L (4V) article.
  5. Remove the 3 bolts and the coolant pump.
    • Remove and discard the gasket.
scientia non olet · About LEMON Manuals