LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Escape Base, 2.5 7, AWD, Standard >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Cooling (Except Hybrid) >> Removal And Installation >> Coolant Pump - 3.0L (4V) >> Installation

Coolant Pump - 3.0L (4V): Installation

  1. Using a new gasket, install the coolant pump and the 3 bolts.
    • Tighten to 10 Nm (89 lb-in).
  2. Install the coolant pump belt. For additional information, refer to ACCESSORY DRIVE - 3.0L (4V) article.
  3. Connect the lower radiator hose to the thermostat housing.
  4. Install the ACL  outlet pipe. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING - 3.0L (4V) article.
  5. Fill and bleed the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING  in this service information.
scientia non olet · About LEMON Manuals