LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Escape Base, 2.5 7, AWD, Standard >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Cooling (Except Hybrid) >> Removal And Installation >> Bypass Tube - 2.5L >> Removal and Installation

Removal and Installation

  1. Drain the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING  in this service information.
  2. Remove the intake manifold. For additional information, refer to ENGINE MECHANICAL - 2.5L article.
  3. Disconnect and remove the coolant bypass tube.
  4. To install, reverse the removal procedure.
  5. Fill and bleed the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING  in this service information.
scientia non olet · About LEMON Manuals