LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Escape Base, 2.5 7, AWD, Standard >> Repair and Diagnosis (Single Page) >> Drivelines & Axles >> Differentials & Drive Axles >> Rear Drive Axle & Differential - Ford 8.8-Inch Ring Gear >> In-Vehicle Repair >> Stub Shaft Seal >> Installation

Stub Shaft Seal: Installation

    NOTE: Lubricate the new stub shaft seal with grease.
    Fig 1: Installing Stub Shaft Seal Using Front Axle Oil Seal Installer And Handle
    G06065012Courtesy of FORD MOTOR CO.
  1. Using the Front Axle Oil Seal Installer and Handle, install the stub shaft seal.
    2. NOTE: Inspect the inboard CV joint seal journal for rust or nicks/scratches prior to installing the halfshaft. If necessary, polish the seal journal with fine crocus cloth.
  2. Install the halfshaft assembly. For additional information, refer to REAR DRIVE HALFSHAFTS article.
scientia non olet · About LEMON Manuals