LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Escape Base, 2.5 7, AWD, Standard >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brake System Actuation >> Removal And Installation >> Brake Pedal Angle Sensor >> Removal and Installation

Removal and Installation

  1. Remove the brake pedal bracket. For additional information, refer to BRAKE PEDAL AND BRACKET - HYBRID  in this service information.
  2. Remove and discard the 2 brake pedal angle sensor screws.
  3. Remove the brake pedal angle sensor.
  4. To install, reverse the removal procedure.
    • Install new brake pedal angle sensor screws.
  5. Carry out the Multi-Calibration Routine. Follow the scan tool directions.
scientia non olet · About LEMON Manuals