LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Escape Base, 2.5 7, AWD, Standard >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrumentation System, Message Center & Warning Chimes >> Removal And Installation >> Instrument Cluster (IC) >> Installation

Instrument Cluster (IC): Installation

  1. Position the IC  , connect the electrical connector and install the 4 instrument cluster screws.
  2. Position the IC  finish panel, connect the instrument panel dimmer switch electrical connector, the ambient air temperature sensor (if equipped) and install the finish panel.
  3. If installing a new IC  , download the IC  configuration information from the scan tool into the new IC  . For additional information, refer to Programmable Module Installation (PMI) in MODULE CONFIGURATION article.
    4. NOTE: If a new IC  is installed, the IC  and the PCM require a parameter reset to allow the IC  and the PCM to recognize each other. Failure to carry out the parameter reset to the IC  and the PCM results in a no start condition.
    NOTE: The vehicle's Passive Anti-Theft System (PATS) keys must be programmed to the new IC  .
  4. If installing a new IC  , carry out the parameter reset and key programming procedure. For additional information, refer to ANTI-THEFT SYSTEM - ANTI-THEFT PERIMETER article (non-hybrid) or ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) - HYBRID article (hybrid).
scientia non olet · About LEMON Manuals