LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Escape Base, 2.5 7, AWD, Standard >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrumentation System, Message Center & Warning Chimes >> Diagnosis And Testing >> Instrumentation, Message Center and Warning Chimes >> Pinpoint Tests >> Pinpoint Test AN: The Key-In-Ignition Warning Chime Is Inoperative >> Pinpoint Test An: The Key-In-Ignition Warning Chime Is Inoperative

Pinpoint Test An: The Key-In-Ignition Warning Chime Is Inoperative

  1. AN1 CHECK THE SAFETY BELT WARNING CHIME OPERATION 
    • Ignition OFF.
    • Ignition ON.
    • Monitor the safety belt warning chime when the ignition switch is transitioned from OFF to RUN for 6 seconds.
    • Does the safety belt warning chime operate for approximately 6 seconds? 
    • Yes:  GO to AN2  .
    • No:  INSTALL a new IC  . REFER to INSTRUMENT CLUSTER (IC)  in this service information. TEST the system for normal operation.
  2. AN2 CHECK THE DOOR AJAR WARNING INDICATOR OPERATION 
    • Ignition ON.
    • Open then close the LH front door while observing the door ajar warning indicator in the IC  message center or the integrated display.
    • Does the door ajar warning indicator operate correctly? 
  3. AN3 RETRIEVE THE RECORDED DTCs FROM THE SJB SELF-TEST 
    • Check for recorded DTCs from the SJB  self-test.
    • Is DTC B1352 present? 
  4. AN4 CHECK THE IGNITION SWITCH 
    • Disconnect: Ignition Switch C250  .
    • Carry out the ignition switch component test.

      Refer to IGNITION SWITCH (14489) for component testing.

    • Is the ignition switch OK? 
    • Yes:  REPAIR circuit CDC30 (BU/GY) for an open. CLEAR the DTCs. REPEAT the self-test.
    • No:  INSTALL a new ignition switch. REFER to STEERING COLUMN SWITCHES article. CLEAR the DTCs. REPEAT the self-test.
scientia non olet · About LEMON Manuals