Parking Brake Cable - Rear, RH

Parking Brake Cable - Rear, RH









Removal and Installation

1. Release the parking brake cable tension. For additional information, refer to Parking Brake Cable Tension Release Procedures.

2. Remove the rear brake shoes. For additional information, refer to Drum Brake Service and Repair.

3. Disconnect the parking brake cable from the cable connector and the equalizer bracket by compressing the cable conduit locking tabs.

4. Compress the retaining clip and detach the parking brake cable from the exhaust support bracket.

5. Remove the parking brake cable bracket bolt.
- To install, tighten to 23 Nm (17 lb-ft).

6. Compress the rear parking brake cable conduit locking tabs and pull the cable assembly through the brake backing plate.





7. To install, reverse the removal procedure.