Seat Cushion Cover - Rear

Seat Cushion Cover - Rear

Removal and Installation

1. Remove the rear seat cushion.
- Position the seat cushion forward.

- Release the locking tab and slide the rear seat cushion outward.





2. Unzip the cushion cover zipper.





3. NOTICE: Use care when separating the seat cushion trim cover from the hook-and-loop strips or the hook-and-loop strips may be torn from the seat cushion foam pad.

Invert and remove the cushion cover.

4. NOTE: Make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.

To install, reverse the removal procedure.