LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Edge Sport, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 854 (Hydraulic Brake System Actuation -- F250-F550 Super Duty) >> General Procedures >> Adjustable Pedal Indexing

Adjustable Pedal Indexing

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: The adjustable pedal system must be indexed whenever the brake pedal assembly or accelerator pedal assembly is installed.
    NOTE: Make sure the electrical connector is connected to the adjustable pedal motor.
  1. Disconnect the adjustable pedal motor drive cable from the brake pedal drive.
    2. Fig 1: Identifying Adjustable Pedal Motor Drive Cable
    GF0006678Courtesy of FORD MOTOR CO.
  2. Operate the accelerator pedal to the full rearward position.
  3. Connect the adjustable pedal motor drive cable to the adjustable brake pedal drive.
  4. Operate the adjustable pedals to the full forward position.
  5. Disconnect the adjustable pedal motor drive cable from the adjustable brake pedal assembly.
  6. Operate the adjustable accelerator pedal to the full forward position.
  7. Connect the adjustable pedal motor drive cable to the adjustable brake pedal drive.
  8. Check that the brake and accelerator pedals can be fully adjusted forward and rearward.
scientia non olet · About LEMON Manuals