Electronic Throttle Body (ETB)

The ETB has the following characteristics:

• The throttle actuator control (TAC) motor is a DC motor controlled by the PCM (requires 2 wires).
• There are 2 designs: parallel and inline. The parallel design has the motor under the bore parallel to the plate shaft. The motor housing is integrated into the main housing. The inline design has a separate motor housing.
• An internal spring is used in both designs to return the throttle plate to a default position. The default position is typically a throttle angle of 7 to 8 degrees from the hard stop angle.
• The closed throttle plate hard stop prevents the throttle from binding in the bore. This hard stop setting is not adjustable and is set to result in less airflow than the minimum engine airflow required at idle.
• The required idle airflow is provided by the plate angle in the throttle body assembly. This plate angle controls idle, idle quality, and eliminates the need for an IAC valve.
• There is one reference voltage and one signal return circuit between the PCM and the ETB. The reference voltage and the signal return circuits are shared with the reference voltage and signal return circuits used by the accelerator pedal position (APP) sensor. There are also 2 throttle position (TP) signal circuits for redundancy. The redundant TP signals are required for increased monitoring reasons. The first TP signal (TPS1-NS) has a negative slope (increasing angle, decreasing voltage) and the second signal (TPS2-PS) has a positive slope (increasing angle, increasing voltage). The TPS2-PS signal reaches a limit of approximately 4.5 volts at approximately 45 degrees of throttle angle.