LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Edge SEL, FWD >> Repair and Diagnosis (Single Page) >> Electrical >> Gauges >> Information Center - Instrumentation, Message Center, And Warning Chimes >> Diagnosis And Testing >> Instrumentation, Message Center and Warning Chimes >> Pinpoint Tests >> Pinpoint Test A: The Instrument Panel Cluster (IPC) Is Inoperative >> Pinpoint Test A: The IPC Is Inoperative

Pinpoint Test A: The IPC Is Inoperative

NOTE: Use the correct probe adapter(s) when making measurements. Failure to use the correct probe adapter(s) may damage the connector.
  1. A1 VERIFY THE IPC PASSES THE NETWORK TEST 
    • Ignition ON.
    • Enter the following diagnostic mode on the scan tool: Network Test.
    • In the LH pane of the Integrated Diagnostic System (IDS) network test display screen, verify whether the IPC  passed the network test.
    • Did the IPC pass the network test? 
  2. A2 RETRIEVE THE RECORDED DTCs FROM THE IPC SELF-TEST 
    • Check for recorded DTCs from the IPC  self-test.
    • Are any DTCs recorded? 
  3. A3 CHECK FOR CORRECT IPC OPERATION 
    • Disconnect the IPC  connector.
    • Check for:
      • corrosion
      • damaged pins
      • pushed-out pins
    • Connect the IPC  connector and make sure it seats correctly.
    • Operate the system and determine if the concern is still present.
    • Is the concern still present? 
    • Yes:  INSTALL a new IPC  . REFER to INSTRUMENT PANEL CLUSTER (IPC) . TEST the system for normal operation.
    • No:  The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector.
scientia non olet · About LEMON Manuals