Removal and Installation
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to
JACKING AND LIFTING
.
- Relieve the tension in the parking brake cable by loosening the parking brake cable equalizer adjustment nut.
Courtesy of FORD MOTOR CO.
- Disconnect the LH parking brake cable from the parking brake cable equalizer.
- Squeeze the tabs and disconnect the LH parking brake cable from the bracket.
- Remove the 3 parking brake cable bracket bolts.
- To install, tighten to 23 Nm (17 lb-ft).
- Remove the stabilizer bar link nut and position the stabilizer bar link aside.
- To install, tighten to 23Nm (17 lb-ft).
- Release the parking brake cable from the brake caliper lever and remove the parking brake cable.
- To install, reverse the removal procedure.