Primary Seal Alignment
- Install the primary seal. Refer to the PRIMARY SEAL ALIGNMENT figure above.
- Install the roof opening panel sliding glass. For additional information, refer to ROOF OPENING PANEL GLASS - FRONT SLIDING .
- Initialize the roof opening panel motor(s). For additional information, refer to ROOF OPENING PANEL MOTOR INITIALIZATION .
NOTE:
The primary seal seam is placed at the rear centerline.
NOTE:
Make sure the primary seal lip is facing outward.
NOTE:
When the roof opening sliding glass panel is in the VENT position, the roof opening panel primary seal should contact the leading edge of the sliding glass.