Removal and Installation
NOTE:
A new heater mat will come assembled on a new foam pad.
- Remove the 60 percent seat. For additional information, refer to SEAT - REAR, 60 PERCENT .
- Release all the cushion trim cover-to-cushion frame retainers and remove the cushion foam pad and cushion trim cover.
- Remove the cushion trim cover in the following sequence.
- Feed the heater mat wire harness and electrical connectors back through the cushion trim cover (if equipped).
- Release the hook-and-loop strips.
- Separate the cushion trim cover wire retainer from the clips in the cushion foam pad and remove the cushion trim cover.
- To install, reverse the removal procedure.
NOTE:
Use care when separating the cushion trim cover from the hook-and-loop strips, or the hook-and-loop strips can be torn from the cushion foam pad.