Seat Cushion - Front: Removal
NOTE:
The air bag warning indicator illuminates when the correct Restraints Control Module (RCM) fuse is removed and the ignition switch is ON.
NOTE:
The Supplemental Restraint System (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.
- Remove the front seat. For additional information, refer to SEAT - FRONT .
- Release all wire harness and connector retainers to the cushion frame.
- For seat with fold-flat backrest, separate the fold-flat recliner cable holders from the bottom of the cushion frame.
- If equipped, disconnect the cushion Thermo-Electric Device (TED) electrical connector.
- If equipped, disconnect the heated seat module and 2 heater mat electrical connectors.
- Separate the pin-type retainers from the cushion frame.
- Remove the 4 cushion frame-to-seat track bolts and cushion assembly.