LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2010 >> Transit Connect Van Cargo >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Information Center - Instrumentation, Message Center And Warning Chimes >> Diagnosis And Testing >> Instrumentation and Warning Chimes >> Principles of Operation >> Warning Chime Characteristics

Warning Chime Characteristics

Each warning chime has unique characteristics that help to identify and differentiate each warning chime. The warning chimes use volume, chime frequency, length of time the chime sounds and the number of chime tones to identify which chime is sounding. The IC  prioritizes the chimes according to a preset hierarchy programmed into the IC  software. Generally, when more than one chime request is received by the IC  , the most important chime sounds. If a lower priority chime is currently sounding, the higher priority request takes over and replaces the lower priority chime.

There are 3 basic chime categories as listed below:

The following table provides a summary of the chime characteristics including the chime priority.

IC Chime Characteristics 

IC CHIME CHARACTERISTICS

Chime Name Chime Type Description
Air bag Repetitive Three tone sequences equaling an overall total of 5 seconds.
Autolock acknowledge Single tone This is a single tone indicating that the autolock programming mode has been entered.
Autolock enable/disable Repetitive (enable)
Single (disable)
A dual tone chime to confirm that the autolock feature is enabled and a single tone chime to confirm that the autolock feature is disabled.
Belt-Minder® Repetitive The Belt-Minder® provides repetitive chime sequences consisting of 6 one-second tones followed by 9.5-seconds off.
The Belt-Minder® sequences repeat for as long as the IC  receives the Belt-Minder® chime request up to 5 minutes.
Door ajar Repetitive A repetitive chime that sounds whenever the IC  receives a door ajar or hood ajar status message.
GEM  service mode Single tone A single tone chime that sounds when entering or exiting the GEM  service mode or during activation of a tested input.
GEM  Transmitter Identification Code (TIC) programming Single tone A single tone chime that sounds when entering the GEM  Remote Keyless Entry (RKE) key transmitter programming mode.
Headlamps on Repetitive A repetitive chime that sounds for as long as the IC  receives a chime request.
Key-in-ignition Repetitive
 
A repetitive chime that sounds for as long as the key is in the ignition with the door ajar.
Not in park Repetitive A repetitive chime that sounds for as long as the transaxle is not in park (P) with the door ajar and the ignition in OFF or ACC position.
Safety belt Repetitive A repetitive chime that sounds for 6 seconds at key ON as long as the safety belt is unbuckled.
Turn signal/hazard Tick-tock A tick-tock sound that is on for as long as the RH/LH turn signal or hazard lamps are on.