LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2010 >> Transit Connect L4-2.0L >> Repair and Diagnosis >> Engine, Cooling and Exhaust >> Engine >> Drive Belts, Mounts, Brackets and Accessories >> Drive Belt Tensioner >> Service and Repair >> Accessory Drive Belt Tensioner

Accessory Drive Belt Tensioner




Accessory Drive Belt Tensioner

Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.

2. Remove the 2 bolts and accessory drive belt splash shield.
- To install, tighten to 9 Nm (80 lb-in).

3. Using the hex feature, rotate the accessory drive belt tensioner clockwise and remove the accessory drive belt from the tensioner.





4. NOTE: The accessory drive belt tensioner must be replaced as a complete unit.

Remove the 2 bolts and the accessory drive belt tensioner.

- To install, tighten to 25 Nm (18 lb-ft).

5. To install, reverse the removal procedure.

scientia non olet · About LEMON Manuals