Removal And Installation
WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- Turn the ignition switch to the OFF position.
- Disconnect the exhaust pressure (EP) sensor electrical connector.
- Remove the EP sensor.
- To install, tighten to 20 Nm (15 lb-ft).
- To install, reverse the removal procedure.
CAUTION:
Make sure the ignition switch is in the OFF position prior to working on the electronic engine controls.
NOTE:
Support the EP sensor tube flange nut when removing the EP sensor.