Selector Lever Knob: Removal

Vehicles equipped with a 2.5L engine 

1. Remove the selector lever trim ring.
   Fig 1: Locating Selector Lever Trim Ring

   Courtesy of FORD MOTOR CO.
2. Remove the center console trim panel.
   Fig 2: Locating Center Console Trim Panel

   Courtesy of FORD MOTOR CO.
3. Disconnect the Transmission Control Switch (TCS) electrical connector.
   Fig 3: Locating Transmission Control Switch Electrical Connector

   Courtesy of FORD MOTOR CO.

   All vehicles 

4. Slide the selector lever knob bezel downward to gain access to the 2 selector lever knob screws.
   NOTE: Fusion/Milan shown in illustration, MKZ similar.
   Fig 4: Sliding Selector Lever Knob Bezel Downward To Gain Access

   Courtesy of FORD MOTOR CO.
5. Remove the 2 screws from the selector lever knob. Remove the selector lever knob and selector lever knob bezel.
   NOTE: For vehicles equipped with a 2.5L engine, it is necessary to route the Transmission Control Switch (TCS) harness out of the selector lever bezel when removing the selector lever knob.
   NOTE: Fusion/Milan shown in illustration, MKZ similar.
   Fig 5: Locating Selector Lever Knob & Bezel

   Courtesy of FORD MOTOR CO.