Symptom Chart

SYMPTOM CHART

Condition	Possible Sources	Action
All dimmable illumination is inoperative	Wiring, terminals or connectors Instrument panel dimmer switch Smart Junction Box (SJB)	GO to PINPOINT TEST A .
All dimmable illumination does not dim	Wiring, terminals or connectors Instrument panel dimmer switch SJB	GO to PINPOINT TEST B .
All dimmable switch illumination is inoperative	Fuse Wiring, terminals or connectors SJB	GO to PINPOINT TEST C .
All dimmable switch illumination is always on	Wiring, terminals or connectors SJB	GO to PINPOINT TEST D .
The steering wheel switch illumination is inoperative	Wiring, terminals or connectors Steering wheel switch(es) Steering wheel harness Clockspring	GO to PINPOINT TEST E .
One or more switch illumination is inoperative	Wiring, terminals or connectors Door lock control switch Headlamp switch Luggage compartment release switch Roof opening panel switch Message center switch Passenger Air Bag Deactivation (PAD)/traction control/ambient lighting switch Floor shifter	GO to PINPOINT TEST F .
The window control switch illumination is inoperative	Window control switch	CHECK the operation of the power windows. If the power windows operate correctly, INSTALL a new window control switch. REFER to GLASS, FRAMES AND MECHANISMS . TEST the system for normal operation. If the power windows do not operate correctly, REFER to GLASS, FRAMES AND MECHANISMS .
All network controlled illumination does not dim	Medium Speed Controller Area Network (MS-CAN) SJB	CARRY OUT the network test. If the scan tool responds with no communication to any module on the MS-CAN , REFER to MODULE COMMUNICATIONS NETWORK . If the scan tool communicates with the modules on the MS-CAN , INSTALL a new SJB . REFER to MULTIFUNCTION ELECTRONIC MODULES . TEST the system for normal operation.
The Instrument Cluster (IC) illumination is inoperative	MS-CAN IC	CARRY OUT the network test. If the scan tool responds with no communication with the IC , REFER to MODULE COMMUNICATIONS NETWORK . If the scan tool communicates with the IC , INSTALL a new IC . REFER to INSTRUMENTATION, MESSAGE CENTER, AND WARNING CHIMES . TEST the system for normal operation.
The Front Display Interface Module (FDIM) illumination is inoperative	MS-CAN FDIM	CARRY OUT the network test. If the scan tool responds with no communication with the FDIM , REFER to MODULE COMMUNICATIONS NETWORK . If the scan tool communicates with the FDIM , INSTALL a new FDIM . REFER to INFORMATION AND ENTERTAINMENT SYSTEMS . TEST the system for normal operation.
The Front Controls Interface Module (FCIM) illumination is inoperative	MS-CAN FCIM	CARRY OUT the network test. If the scan tool responds with no communication with the FCIM , REFER to MODULE COMMUNICATIONS NETWORK . If the scan tool communicates with the FCIM , INSTALL a new FCIM . REFER to INFORMATION AND ENTERTAINMENT SYSTEMS . TEST the system for normal operation.
The HVAC module illumination is inoperative	MS-CAN HVAC module	CARRY OUT the network test. If the scan tool responds with no communication with the HVAC module, REFER to MODULE COMMUNICATIONS NETWORK . If the scan tool communicates with the HVAC module, INSTALL a new HVAC module. REFER to CLIMATE CONTROL . TEST the system for normal operation.