Instrument Cluster (IC) DTC Chart
INSTRUMENT CLUSTER (IC) DTC CHART
| DTC | Description | Action |
|---|---|---|
| B1202 | Fuel Sender Circuit Open | GO to PINPOINT TEST B . |
| B1204 | Fuel Sender Circuit Short to Ground | GO to PINPOINT TEST B . |
| B1205 | EIC Switch-1 Assembly Circuit Failure | INSTALL a new message center switch. REFER to MESSAGE CENTER SWITCH . CLEAR the DTCs. REPEAT the self-test. |
| B1206 | EIC Switch-1 Assembly Circuit Open | GO to PINPOINT TEST AD . |
| B1208 | EIC Switch-1 Assembly Circuit Short To Ground | GO to PINPOINT TEST AD . |
| B1213 | Anti-Theft Number of Programmed Keys Is Below | Minimum REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) . |
| B1317 | Battery Voltage High | GO to PINPOINT TEST AK . |
| B1318 | Battery Voltage Low | GO to PINPOINT TEST AL . |
| B1342 | ECU Is Faulted | REPAIR all other DTCs first. CLEAR the DTCs. REPEAT the self-test. If DTC B1342 is retrieved again, INSTALL a new IC . REFER to INSTRUMENT CLUSTER (IC) . TEST the system for normal operation. |
| B1600 | PATS Ignition Key Transponder Signal Is Not Received | REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) . |
| B1601 | PATS Received Incorrect Key-Code From Ignition Key Transponder | REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) . |
| B1602 | PATS Received Invalid Format Of Key-Code From Ignition Key Transponder. | REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) . |
| B1681 | PATS Transceiver Module Signal Is Not Received | REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) . |
| B1868 | Lamp Air Bag Warning Indicator Circuit Failure | If DTCs U2472 and DTC B1868 are both present, GO to PINPOINT TEST AK to diagnose DTC U2472 first. If only DTC B1868 is present, INSTALL a new IC. REFER to INSTRUMENT CLUSTER (IC) . TEST the system for normal operation. |
| B1870 | Lamp Air Bag Warning Indicator Circuit Short To Battery | INSTALL a new IC . REFER to INSTRUMENT CLUSTER (IC) . TEST the system for normal operation. |
| B2097 | Compass Module Failure | REFER to ELECTRONIC COMPASS . |
| B2103 | Antenna Not Connected | REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) . |
| B2141 | NVM Configuration Failure CARRY OUT the parameter reset. | REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) . TEST the system for normal operation. |
| B2143 | NVM Memory Failure | GO to PINPOINT TEST I . |
| B2431 | Transponder Programming Failed | REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) . |
| B2477 | Module Configuration Failure | REFER to MODULE CONFIGURATION . |
| C1093 | Traction Control Disable Switch Circuit Failure | REFER to VEHICLE DYNAMIC SYSTEMS . |
| U0100 | Lost Communication With ECM/PCM | REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) . |
| U0101 |
NOTE:
This DTC is used for all messages or data received from the PCM except any Passive Anti-Theft System (PATS) messages. Lost Communication With TCM |
GO to PINPOINT TEST AM . |
| U0121 | Lost Communication With Anti-Lock Brake System (ABS) Control Module | GO to PINPOINT TEST AN . |
| U0140 | Lost Communication With Body Control Module(GEM ) | GO to PINPOINT TEST AO . |
| U0151 | Lost Communication With Restraints Control Module(RCM ) | GO to PINPOINT TEST AP . |
| U0164 | Lost Communication With HVAC Control Module(EATC ) | GO to PINPOINT TEST AQ . |
| U2013 | Compass Module Is Not Responding | REFER to ELECTRONIC COMPASS . |
| U2023 | Fault Received From External Node | DTC U2023 is set when a module receives invalid network data from another module with a faulted input. RETRIEVE and REPAIR all non-network DTCs in the other modules on the network. REFER to MULTIFUNCTION ELECTRONIC MODULES for a list of all DTCs. |
| U2050 | No Application Present | CARRY OUT the Programmable Module Installation (PMI) procedure for the IC
. REFER to
MODULE CONFIGURATION
. If the DTC reappears, INSTALL a new IC . REFER to INSTRUMENT CLUSTER (IC) . TEST the system for normal operation. |
| U2198 | Invalid 'Fuel Pulse' Data | REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) . |
| U2200 | Invalid 'ODO Count' Data | REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) . |
| U2472 | Unexpected Ignition State | GO to PINPOINT TEST AR . |
| U2510 | CAN -Invalid Data For Vehicle Security | REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) . |
| U2511 | CAN -Data Mis-Match (Receive data does not match expected) | REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) . |