Removal and Installation

Both cables 

1. Release the parking brake cable tension. For additional information, refer to PARKING BRAKE CABLE TENSION RELEASE .

   RH cable 

2. Separate the RH cable from the LH at the conduit equalizer and remove the cable from the wireform bracket.
3. Remove the 3 parking brake cable bracket bolts.
   • To install, tighten to 15 Nm (133 lb-in).
4. Remove the RH wheel well bracket bolt.
   • To install, tighten to 23 Nm (17 lb-ft).

   LH cable 

5. Disconnect the conduit equalizer from the RH cable at the equalizer.
6. Remove the wireform bracket bolt and separate the LH cable and bracket from the RH cable.
   • To install, tighten bolt to 12 Nm (106 lb-in).
7. Remove the LH wheel well bracket bolt.
   • To install, tighten to 23 Nm (17 lb-ft).

   Both cables 

8. Release the parking brake cable from the brake caliper and remove the cable.
9. To install, reverse the removal procedure.
   • Inspect the parking brake system for correct operation.