LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2010 >> Flex SE >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brake System Actuation >> Description And Operation >> Inspection And Verification >> Adjustable Pedals

Adjustable Pedals

  1. Verify the customer concern by operating the adjustable pedals.
  2. Visually inspect for obvious signs of mechanical or electrical damage.
    VISUAL INSPECTION CHART

    Mechanical Electrical
    • Adjustable brake pedal cable
    • Adjustable pedal motor
    • Adjustable brake and accelerator pedals
    • Foreign material
    • Adjustable pedal switch
    • Driver Seat Module (DSM)
    • Memory SET switch
    • Remote Keyless Entry (RKE) transmitter
    • Battery Junction Box (BJB) fuse 32 (30A)
    • Smart Junction Box (SJB) fuse(s):
      • 13 (5A)
      • 20 (15A)
    • Wiring, terminals or connectors
  3. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
  4. NOTE: Make sure to use the latest scan tool software release.

    If the cause is not visually evident, connect the scan tool to the Data Link Connector (DLC).

  5. NOTE: The Vehicle Communication Module (VCM) LED prove out confirms power and ground from the DLC  are provided to the VCM  .

    If the scan tool does not communicate with the VCM  :

    • check the VCM connection to the vehicle.
    • check the scan tool connection to the VCM  .
    • Refer to MODULE COMMUNICATIONS NETWORK , No Power To The Scan Tool, to diagnose no power to the scan tool.
  6. If the scan tool does not communicate with the vehicle:
    • verify the ignition is ON.
    • verify the scan tool operation with a known good vehicle.
    • Refer to MODULE COMMUNICATIONS NETWORK to diagnose no response from the PCM.
  7. Carry out the network test.
    • If the scan tool responds with no communication for one or more modules, Refer to MODULE COMMUNICATIONS NETWORK .
    • If the network test passes, retrieve and record Continuous Memory Diagnostic Trouble Codes (CMDTCs).
  8. Clear the continuous DTCs and carry out the self-test diagnostics for the Driver Seat Module (DSM).
  9. If the DTCs retrieved are related to the concern, go to DRIVER SEAT MODULE (DSM) DTC CHART . For all other DTCs, refer to the Master DTC Chart in MULTIFUNCTION ELECTRONIC MODULES .
  10. If no DTCs related to the concern are retrieved, GO to SYMPTOM CHART - ADJUSTABLE PEDALS .
scientia non olet · About LEMON Manuals