Accessory Drive Belt Idler Pulley

Accessory Drive Belt Idler Pulley - 4.6L (3V)

Removal and Installation

1. Remove the air cleaner outlet pipe. For additional information, refer to Fuel Delivery and Air Induction.

2. Rotate the accessory drive belt tensioner clockwise and remove the drive belt.





3. NOTE: The 4.6L (3V) has 3 idler pulleys, an upper RH, an upper LH and a lower LH.

Remove the bolt and the accessory drive belt idler pulley.

- To install, tighten to 25 Nm (18 lb-ft).

4. To install, reverse the removal procedure.
- For correct belt routing, refer to Accessory Drive Description and Operation, Accessory Drive Belt Routing, Front End Accessory Drive (FEAD) - 4.6L (3V) in the Description and Operation.