LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2010 >> Expedition RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 759 (Parking Brake System & Actuation - F150 & Mark LT) >> Removal And Installation >> Parking Brake Control >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable. For additional information, refer to GENERATOR AND REGULATOR article.
  2. Remove the LH cowl side trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION article.
  3. Release the tension on the parking brake cable. For additional information, refer to Parking Brake Cable Tension Release  .
  4. Remove the parking brake release handle bolt and pull the handle assembly down to prevent breaking off the locator tabs.
  5. Disconnect the parking brake release handle cable from the parking brake control.
  6. Disconnect the parking brake switch electrical connector.
  7. Remove the 3 bolts from the parking brake control.
    • To install, tighten to 20 Nm (15 lb-ft).
  8. Position the cable conduit grommet up through the floor.
    • Release the cable from the parking brake control.
  9. Remove the parking brake control from the vehicle.
  10. To install, reverse the removal procedure.
    • Inspect the parking brake system for correct operation.
scientia non olet · About LEMON Manuals