Removal and Installation
- Relieve the tension on the parking brake cable system. For additional information, refer to PARKING BRAKE CABLE TENSION RELEASE .
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
- Separate the LH rear cable from the equalizer.
- Compress the 2 tabs and remove the conduit from the bracket.
- Disconnect the parking brake cable retainer spring from the cable.
- Disconnect the LH rear cable from the retaining clip.
- Disconnect the ABS wheel speed sensor wire from the retaining clip.
- Release the parking brake cable from the LH bracket assembly.
- Release the cable from the parking brake actuating lever and remove the cable.
- To install, reverse the removal procedure.
NOTE:
Be sure to correctly install the park brake cable retainer spring and route cables between suspension links.