Removal and Installation
- Remove the parking brake control. For additional information, refer to PARKING BRAKE CONTROL .
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
- Remove the front park brake cable P-clip-to-frame bolt.
- To install, tighten to 18 Nm (159 lb-in).
- Remove the front parking brake cable and conduit.
- Pry the rubber seal from the front floor pan.
- Compress the retainer and release the conduit from the bracket.
- Remove the front cable and conduit from the cable union.
- To install, reverse the removal procedure.