LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Taurus X SEL, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1403 (Anti-Theft System - Perimeter) >> Removal And Installation >> Door Disarm Switch >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2009 Mercury Grand Marquis and 2009 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the LH front door trim panel. For additional information, refer to INTERIOR TRIM & ORNAMENTATION article.
  2. Position the watershield aside.
  3. Disconnect the door lock cylinder actuating rod from the door lock cylinder actuating pawl.
  4. Remove the E-clip.
  5. Remove the door lock cylinder actuating pawl.
  6. Disconnect the electrical connector and remove the door disarm switch.
  7. To install, reverse the removal procedure.
    • The door disarm switch mark must be positioned toward the harness side of the switch prior to installation.
    8. Fig 1: Identifying Door Disarm Switch Mark
    GF0001423Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals