LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Taurus X SEL, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1398 (Seat System - Seating) >> Disassembly And Assembly >> Seat Armrest - Rear >> Disassembly And Assembly

Disassembly And Assembly

WARNING: This page is about a different car, the 2009 Mercury Grand Marquis and 2009 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
    WARNING: Before servicing a vehicle equipped with a fire suppression system, depower the system by following the procedure in FIRE SUPPRESSION SYSTEM article. Failure to follow the instructions may result in serious personal injury.
  1. For police vehicles equipped with a fire suppression system, depower the system.
  2. Remove the armrest. For additional information, refer to Seat Armrest - Rear .
  3. Remove the rubber inserts from the armrest cup holder.
  4. Remove the 2 screws from the armrest cup holder.
  5. Remove the 2 pivot screws from the armrest.
  6. Remove the hog rings.
    7. Fig 1: Hog Rings
    GF0013137Courtesy of FORD MOTOR CO.
  7. Remove the armrest trim cover.
  8. To assemble, reverse the disassembly procedure.
    9. WARNING: If the vehicle is equipped with a fire suppression system, repower the system. For important safety warnings and procedures, refer to FIRE SUPPRESSION SYSTEM article. Failure to follow these instructions may result in serious personal injury.
  9. For police vehicles equipped with a fire suppression system, repower the system.
scientia non olet · About LEMON Manuals