Removal And Installation

WARNING: This page is about a different car, the 2009 Mercury Grand Marquis and 2009 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.

Remove the air suspension compressor. For additional information, refer to Air Suspension Compressor .
Remove the air suspension compressor drier.
1. Remove the screw.
  - To install, tighten to 3 Nm (27 lb-in).
2. Rotate the air compressor drier 90 degrees to unlock, then remove the air suspension compressor drier.

Fig 1: Rotating Air Compressor Drier 90 Degrees

Courtesy of FORD MOTOR CO.

NOTE: Inspect the O-ring for damage and install a new O-ring as necessary. Lubricate the solenoid seal area with grease.

NOTE: When installing the air tubes, make sure the white tube is fully inserted into the fitting for correct installation.

NOTE: Ride height adjustments must be carried out after the air suspension compressor/drier is installed.

To install, reverse the removal procedure.