Removal And Installation

WARNING: This page is about a different car, the 2009 Mercury Grand Marquis and 2009 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.

Drain the engine coolant. For additional information, refer to ENGINE COOLING article.
Remove the nuts and position the vapor management valve (VMV) aside.

Fig 1: Vapor Management Valve Nuts

Courtesy of FORD MOTOR CO.

Release the clamps and disconnect the heater hoses from the heater core.

Fig 2: Heater Hose Clamps At Core

Courtesy of FORD MOTOR CO.

Release the clamp and remove the heater hose.

Fig 3: Heater Hose Clamp

Courtesy of FORD MOTOR CO.

Remove the blower motor speed control.
1. Disconnect the blower motor speed control electrical connector.
2. Remove the 2 blower motor speed control screws.
3. Remove the blower motor speed control.

Fig 4: Blower Motor Speed Control

Courtesy of FORD MOTOR CO.

To install, reverse the removal procedure.