Crankshaft Rear Seal: Removal
WARNING: This page is about a different car, the 2009 Mercury Grand Marquis and 2009 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING article.
- Remove the flexplate. For additional information, refer to Flexplate .
- Using the Crankshaft Rear Oil Slinger Remover and Slide Hammer, remove the crankshaft oil slinger.
- Using the Crankshaft Rear Oil Seal Remover and Slide Hammer, remove the crankshaft rear seal.
WARNING:
Before servicing a vehicle equipped with a fire suppression system, depower the system by following the procedure in FIRE SUPPRESSION SYSTEM
article. Failure to follow the instructions may result in serious personal injury.