LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Taurus X SEL, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1341 (Fire Suppression System) >> Removal & Installation >> Fire Suppression Manual Switch >> Removal & Installation

Removal & Installation

WARNING: This page is about a different car, the 2009 Mercury Grand Marquis and 2009 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery. For additional information, refer to BATTERY, MOUNTING & CABLES article.
    2. NOTE: Care must be taken when releasing the fire suppression manual switch clips to avoid damaging the switch and the headliner.
  2. Release the fire suppression manual switch from the headliner and position it aside.
  3. Position the RH and LH front door weatherstrips aside.
  4. Remove the RH and LH windshield side garnish moldings.
  5. Remove the RH and LH sun visors and the center receptacles.
    6. NOTE: Care must be taken when lowering the front of the headliner to avoid damaging the headliner.
  6. Lower the front portion of the headliner.
  7. Remove the fire suppression manual switch.
    • Disconnect the electrical connector.
    8. NOTE: Care must be taken when installing the fire suppression manual switch to avoid folding or pinching the ribbon harness.
  8. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals