Clutch Disc and Pressure Plate - 4.0L: Installation
WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
If installing the original pressure plate, align it using the index marks made during removal.
NOTE:
Always install new pressure plate bolts.
- Inspect the flywheel. For additional information, refer to Flywheel Runout Check in MANUAL TRANSAXLE/TRANSMISSION CLUTCH - GENERAL INFORMATION article.
- Using a suitable clutch aligner, position the clutch disc on the flywheel, then install the pressure plate and 6 new pressure plate bolts.
- Tighten the bolts in a star pattern.
- Tighten to 35 Nm (26 lb-ft).
- Install the transmission. For additional information, refer to MANUAL TRANSAXLE/TRANSMISSION - T5OD article.
- Bleed the clutch hydraulic system. For additional information, refer to MANUAL TRANSAXLE/TRANSMISSION CLUTCH - GENERAL INFORMATION article.
NOTE:
Before securing the transmission to the engine, connect the clutch hydraulic tube to the slave cylinder.