LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Taurus X SEL, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1325 (Engine Mechanical - 4.6L (3V)) >> In-Vehicle Servicing >> Flexplate >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the transmission. For additional information, refer to AUTOMATIC TRANSAXLE/TRANSMISSION - 5R55S .
  2. Remove the 6 bolts and the flexplate.
    • To install, tighten to 80 N.m (59 lb-ft) in the sequence shown.
    3. Fig 1: Identifying Flexplate Bolts Tightening Sequence
    GF0015187Courtesy of FORD MOTOR CO.
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals