Removal And Installation

WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
Remove the Throttle Body (TB). For additional information, refer to FUEL CHARGING AND CONTROLS - 4.0L SINGLE OVERHEAD CAMSHAFT (SOHC) .
Remove the Front End Accessory Drive (FEAD) bracket bolt and install the Engine Lifting Bracket.
- To install, tighten to 48 Nm (35 lb-ft).

Fig 1: Locating Front End Accessory Drive (FEAD) Bracket Bolt

Courtesy of FORD MOTOR CO.

Remove the 6 pin-type retainers and the radiator sight shield.

Fig 2: Locating Pin-Type Retainers And Radiator Sight Shield

Courtesy of FORD MOTOR CO.

Install the Engine Support Bar.

Fig 3: Identifying Special Tool 303-F072

Courtesy of FORD MOTOR CO.

Remove the engine mount bracket-to-engine mount nut.
- To install, tighten to 63 Nm (46 lb-ft).
Remove the 3 engine mount bracket bolts and remove the bracket.
- To install, tighten to 80 Nm (59 lb-ft).
Remove the 2 engine mount bolts and the engine mount.
- To install, tighten to 70 Nm (52 lb-ft).
To install, reverse the removal procedure.