Valve Cover - RH: Installation
WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
- Install new gaskets. Make sure the gaskets are correctly seated on the valve cover.
- Apply a bead of silicone gasket and sealant in 2 places where the engine front cover meets the cylinder head.
- Install the RH valve cover, the 7 bolts and 3 stud bolts.
- Tighten in the sequence shown to 10 Nm (89 lb-in).
- Attach the wiring harness pin-type retainer to the rear of the intake manifold.
- Attach the 3 wiring harness retainers to the RH valve cover studs.
- Connect the ECT sensor electrical connector.
- Connect the fuel rail pressure and temperature sensor electrical connector.
- Connect the 4 RH fuel injector electrical connectors.
- Install the RH radio interference capacitor and the nut.
- Tighten to 10 Nm (89 lb-in).
- Connect the PCV valve electrical connector.
- Install the crankcase ventilation tube.
- Install the RH ignition coils. For additional information, refer to ENGINE IGNITION - 5.4L (4V) .
- Install the 4 nuts and the strut tower cross brace.
- Tighten to 35 Nm (26 lb-ft).
- Install the battery and tray. For additional information, refer to BATTERY, MOUNTING AND CABLES .
NOTE:
If the valve cover is not secured within 4 minutes, the sealant must be removed and the sealing area cleaned with metal surface prep. Allow to dry until there is no sign of wetness, or 4 minutes, whichever is longer. Failure to follow this procedure can result in future oil leakage.
Fig 2: Applying Bead Of Silicone Gasket & Sealant In 2 Places Where Engine Front Cover Meets Cylinder Head