LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Taurus X SEL, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1308 (Seat System - Seating) >> Disassembly And Assembly >> Seat Backrest - Rear, Coupe >> Disassembly

Seat Backrest - Rear, Coupe: Disassembly

WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear seat cushion. For additional information, refer to Seat Cushion - Rear .
  2. Remove the rear seat backrest. For additional information, refer to Seat Backrest - Rear .
  3. Release the backrest trim cover J-strip and remove the staples.
  4. Pull the backrest panel out from the backrest foam pad and backrest trim cover.
    • Upon assembly, the latch release strap must come through the trim cover.
  5. Remove the 4 rivets and the pivot brackets.
  6. Remove the rivets, separate the pin-type retainer from the cable end and remove the backrest latch assembly.
    7. CAUTION: Use care when separating the seat backrest trim cover from the hook-and-loop strip. The hook-and-loop strip can be torn from the seat backrest foam.
  7. Release the hook-and-loop strips and separate the backrest trim cover from the backrest foam pad.
  8. To assemble, reverse the disassembly procedure.
scientia non olet · About LEMON Manuals