Window Glass Adjustment - Front Door, Height Stop Adjustment

WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The LH or RH front window motor must be de-initialized, then initialized whenever the front window motor is removed from the window regulator, a new window regulator and motor is installed, a new window glass is installed or for any operation in which grease or lubricants are applied to the window regulator or glass run.

Remove the door trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
Close the door.
Raise the door window glass to the desired height.

NOTE: Door window front height adjustment shown, door window rear height adjustment similar.

Lower the window to access the door window front and rear height stop adjustments.

Fig 1: Locating Door Window Front Height Adjuster

Courtesy of FORD MOTOR CO.

Adjust the door window front and rear height stop adjustments to achieve the desired door window height.
Install the door trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
Initialize the LH or RH front window motor. For additional information, refer toWindow Motor Initialization .