LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Taurus X SEL, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1290 (Engine Cooling System) >> Removal And Installation >> Thermostat - 4.6L (3V) >> Removal

Thermostat - 4.6L (3V): Removal

WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Drain the engine cooling system. For additional information, refer to Cooling System Draining, Filling and Bleeding .
  3. Remove the Air Cleaner (ACL) outlet pipe. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING .
  4. Remove the accessory drive belt. For additional information, refer to ACCESSORY DRIVE .
  5. Disconnect the crankcase vent tube from the intake manifold and position it aside.
  6. Remove the 2 generator support bracket outer bolts.
  7. Remove the 2 lower generator nuts and position the generator and wiring harness forward.
  8. Loosen the 2 generator support bracket inner bolts and position aside the generator and wiring harness.
    9. NOTE: RH thermostat cover bolt has a slotted flange.
  9. Remove the LH thermostat cover bolt and loosen the RH bolt.
    • Position aside the thermostat cover and hose assembly.
  10. Remove the thermostat O-ring seal and the thermostat.
    • Discard the thermostat O-ring seal.
scientia non olet · About LEMON Manuals