LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Taurus X SEL, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1278 (Front Disc Brake System) >> Removal And Installation >> Front Brake Pads - 4.0L SOHC and 4.6L (3V) >> Removal

Front Brake Pads - 4.0L SOHC and 4.6L (3V): Removal

WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Do not use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that has been previously drained. Following these instructions will help prevent system contamination, brake component damage and the risk of serious personal injury.
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.
CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with water.
  1. Check the brake fluid level in the brake fluid reservoir.
    • If required, remove fluid until the brake master cylinder reservoir is half full.
  2. Remove the wheel and tire. For additional information, refer to WHEELS AND TIRES article.
    3. CAUTION: Do not use the caliper sight hole to retract pistons as this may damage the pistons and boots.
    CAUTION: Do not allow the brake caliper, brake pads and anchor plate assembly to hang from the brake hose or damage to the hose may occur.
  3. Remove and discard the 2 brake caliper guide pin bolts and position the brake caliper aside.
    • Support the brake caliper using mechanic's wire.
    4. CAUTION: Install new brake pads if they are worn past the specified thickness above the metal backing plates. Install new brake pads in axle sets or brake drag/brake pull may occur.
  4. Remove the brake pads and discard the 4 spring clips.
  5. Inspect the brake caliper.
  6. Inspect the brake caliper anchor plate assembly.
    • Check the guide pins and boots for binding or damage.
    • Lubricate the guide pins with the specified grease.
    • Install a new brake caliper anchor plate if it is worn or damaged. For additional information, refer to Brake Caliper - 4.0L SOHC and 4.6L (3V) .
scientia non olet · About LEMON Manuals