Power Steering Pump Pulley - 4.6L, 5.4L: Installation

WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.

4.6L and 5.4L engines

NOTE: Installation of a new power steering pump pulley is necessary after being removed and installed 2 times or pulley and/or pump failure may occur.

Using the Power Steering Pump Pulley Installer, install the pulley.
- Inspect the pulley for paint marks in the web area near the hub. If there are 2 paint marks, install a new pulley. If there is no paint or one paint mark, use a paint pencil to mark the web area of the pulley near the hub.

Fig 1: Installing Pulley Using Special Tool 211-185

Courtesy of FORD MOTOR CO.

Rotate the tensioner and install the accessory drive belt to the power steering pump pulley. For additional information on the accessory drive belt routing, refer to ACCESSORY DRIVE .

4.6L engine

Install the air cleaner outlet pipe. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING .