Axle Shaft: Removal

WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
Remove the rear brake disc. For additional information, refer to REAR DISC BRAKE .

NOTE: Damage to the rear brake anti-lock sensor may occur if it is not removed before the axle shaft U-washer.

Remove the anti-lock sensor bolt, then remove the anti-lock sensor from the hub.

Fig 1: Identifying Anti-Lock Sensor & Bolt

Courtesy of FORD MOTOR CO.

Remove the differential housing cover. For additional information, refer to Differential Housing Cover .
Remove the differential pinion shaft.
1. Remove and discard the differential pinion shaft lock bolt.
2. Remove the differential pinion shaft.

Fig 2: Locating Differential Pinion Shaft And Lock Bolt

Courtesy of FORD MOTOR CO.

NOTE: Do not damage the rubber O-ring in the axle shaft grooves.

Remove the axle shaft U-washer.
1. Push in on the axle shaft.
2. Remove the U-washer.

Fig 3: Removing The U-Washer

Courtesy of FORD MOTOR CO.

NOTE: Do not damage the axle shaft oil seal.

Remove the axle shaft.

Fig 4: Locating Axle Shaft

Courtesy of FORD MOTOR CO.