Driveline System

The driveline system consists of the following components:

• Rear drive axles with varying diameter ring gears and differential designs
• One-piece rear driveshaft with 2 U-joints and a front slip yoke or flange
• Two-piece rear driveshaft with a CV joint and a center support bearing
• Conventional axle - Ford 7.5-in ring gear
• Conventional axle - Ford 8.8-in rear axle
• Limited slip axle - Ford 8.8-in rear axle

The source of the drivetrain's power is generated by the engine and delivered to the transmission. The driveline transfers the engine torque through the driveshaft to the axle. The driveshaft is connected to the output shaft of the transmission and to the axle. Vehicles with 4.0L engines use U-joints at both ends of the driveshaft to allow for angular motion. A slip-in-tube driveshaft is used to allow for any changes to the length of the driveshaft. Vehicles with 4.6L or 5.4L engines use a CV joint in the rear of the driveshaft and a U-joint in the front. A center bearing and the CV joint allow for length changes to the driveshaft. The engine torque enters the axle through the drive pinion, which rotates the ring gear. The ring gear is mounted to the differential case, which contains the gears that transmit power to the axle shafts. These shafts rotate the drive wheels.

The Vehicle Certification (VC) label is located in the driver door jamb. The axle code is on the VC label. Refer to IDENTIFICATION CODES article.

Fig 1: Vehicle Certification (VC) Label Example

Courtesy of FORD MOTOR CO.

Fig 2: Rear Axle Identification Label

Courtesy of FORD MOTOR CO.